03.12.2015Copyrigth (c) Product Managment Leister 1 January 2010 VARIMAT V2 Instruction manual Bitumen Kit Product Marketing Manager Roland Beeler October.

18.04.23 Copyrigth (c) Product Managment Leister

1

January 2010

VARIMAT V2Instruction manual

Bitumen Kit

Product Marketing Manager

Roland Beeler

October 2013

18.04.23Page 2Copyrigth (c) Product Managment Leister

Kit overview

1. Pressure wheel with protection coverage

2. Bitumen nozzle3. Additional weight for more

pressure4. Heating element 6100W for 400V

version5. Connection link 6. Suspension Spring, for proper

balancing of the frame.

1.

2.

3.

4.

5.

6.


Step 1

• Change pressure wheel


Step 2

• Install protection coverage


Step 3

• Swing the air dam pulley down to expose the suspension spring. Remove the standard spring assembly. Insert the new suspension spring assembly into the tapped hole in the underside of the VARIMAT V2. The spring must be installed for proper balancing of the frame.


Step 4

• Replace the air dam belt: Slide the green air dam belt over the Wide Weld pressure wheel so that it sits in the groove at the bottom of the Wide Weld pressure wheel. Ensure the air dam belt is not twisted. Pull the air dam belt to the rear air dam pulley, ensuring that the air dam belt is in the track grooves of the two intermediate pressure wheels.


Step 5

• Remove the back-roller slide-plate knob.• Install connection link


Step 6

• Change heating element for 400V version


Step 7

• Carefully slide the new nozzle over the mica tube and use the four mounting screws that were on the 40-mm nozzle. Ensure the ground wire is reconnected.


Step 8

• Do the nozzle alignment if necessary


Thanks for your

attention

03.12.2015Copyrigth (c) Product Managment Leister 1 January 2010 VARIMAT V2 Instruction manual Bitumen Kit Product Marketing Manager Roland Beeler October.

Documents