INTRODUCTION XPROG-m Errata Sheet 001 This errata provides information applicable to the following products: ● 1-002-0017 programming adapter Rev.B or earlier These changes allow you to work with secured ARM MCU via JTAG interface STEP1 Remove this resistor STEP2 ● Prepare the four wires. About 5cm in length. 1A 2A 3A 4A 1B 2B 3B 4B 1A 3A 2A 4A STEP3 ● Solder wire shown in the corresponding points at the bottom side 2B 3B 4B 1B STEP4 ● Solder wire shown in the corresponding points at the top side © 2009 TMT www.uobd2.com E-Mail:[email protected] MSN:[email protected] Tel:0086-13986168065 SKYPE:greebid6 www.uobd2.com www.uobd2.com
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
INTRODUCTIONXPROG-m Errata Sheet 001
This errata provides information applicable to the following products:● 1-002-0017 programming adapter Rev.B or earlier
These changes allow you to work with secured ARM MCU via JTAG interface
STEP1
Remove this resistor
STEP2
● Prepare the four wires. About 5cm in length.
1A
2A
3A
4A
1B
2B
3B
4B
1A
3A
2A 4A
STEP3
● Solder wire shown in the corresponding points at the bottom side
2B
3B
4B1B
STEP4
● Solder wire shown in the corresponding points at the top side
© 2009 TMT
www.uobd2.com
E-Mail:[email protected] MSN:[email protected] Tel:0086-13986168065 SKYPE:greebid6
www.uobd2.com
www.uobd2.com
Related Documents
