This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
www.elfa.comwww.elfarus.ru
Insert the closet rod holderInsert the closet rod holder into the slot in the bottom of the bracket click in.
1
2Snap in the closet rodTap the end caps into both ends of the closet rod.
Snap the closet rod into the closet rod holder.
Installing closet rods that share a closet rod holder
First, install joined rods in the center of the closet rod holder, then place the outer ends in the closet rod holder.
Tap the end caps only into the non-joined ends of each closet rod. Adding end caps to the joined ends creates a gap.
Установите подвеску для штанги в прорезь снизу кронштейна.
anmind
Машинописный текст
anmind
Машинописный текст
anmind
Машинописный текст
anmind
Машинописный текст
Вначале установите торцевые заглушки по краям штанги. Установите штангу для вешалок в подвеску сверху вниз до плотного прилегания.
anmind
Машинописный текст
anmind
Машинописный текст
Установите торцевые заглушки с внешних сторон штанг. В месте сочленения заглушки не устанавливаются. Установите штанги в центральную подвеску плотно друг к другу, затем закрепите внешние концы штанг в индивидуальных подвесках.