Transcript
Pattern & Guidelines for
WELDING ASSIGNMENT
1st YEAR– All Braches
General Instruction•The assignment must be submitted within two weeks from the date of attending the workshop.•Use loose Interleaf Sheets.•Prepare assignment only as per the Contents given on the next page.•The Visuals like diagrams/sketches/pictures should be exactly opposite to the respective write-up/ Content only. •Visuals at an inappropriate place is of no use, rather contains confusion to the reader & even to yourself.•Xeroxed /Print-out of Pictures (if required) can be pasted.•Sketches & Diagrams have to be drawn only. •Preferably Outer lines may be high-lightened with black ball pen.•Proper labeling/nomenclature of sketches / diagrams is very important.•The assignment has to be prepared in the same sequence as mentioned in the Index.•All the contents may not be available from a single book. Therefore other books / web sites may be referred.
Suggested Pattern of Assignment follows --------->>>>>>>>>>next page onwards.
Its only for reference.There’s always a scope of betterment.New ideas & innovations will be appreciated.
Welding Shop
Shop Attended on:- (Date)Name of the Job Performed:-Assignment submitted on:- (date)
Submitted by:-Name-Roll No. – Class ,Section & Group -
INDEXSr. Title Page No. Remarks
1 Layout of Welding Workshop
2 Introduction – Welding
3 Welding Classification -Tabular Format
4 Fusion Welding – Brief Explanation
5 Pressure Welding – Brief Explanation
6 Gas - Oxy Acetylene Welding
6 (a) Process
6 (b) Equipment / Set up
7 Electric Arc Welding – SMAW
7 (a) Process
7 (b) Equipment / Set up
8 Welding Joints (Main 5 Joints only)
9 Welding Defects
10 Advantages & Disadvantages of Welding Process over other Joining Processes
11 Safety Precautions
12 Job Performed
LegendsWelding Symbols & Abbreviations
Symbol / Abbr. Relates to
Welding Workshop Layout
Welding Classification
To be drawn in Tabular Format (like Organization Chart)Separately for Fusion & Pressure Welding on Separate pages
Fusion Welding :-
Pressure Welding:-
Gas (Oxy-Acetylene) Welding:-
Process:-
Equipment /Set up:-
Electric Arc Welding:-
Shielded Metal Arc Welding:-
Process:-
Equipment /Set up:-
Welding JointsOnly Sketches to be drawn, which should be self- explanatory.
Write up not necessary(Following sketches are for reference only. You may find / draw better)
Two options have been give; 1st on this slide & 2nd on the next. Any one may be selected
Welding Joints
Welding SymbolsMay be used at the appropriate page
(Following sketches are for reference only. You may find / draw better)
Welding Defects
Welding Defects
Welding Defects
Distortion
Welding Cracks
UndercutUndercut
Welding Porosity
UNDERCUT
POROSITY
INCOMPLETE FUSION
OVERLAP
UNDERFILL
SPATTER
EXCESSIVE CONVEXITY
EXCESSIVE CONCAVITY
EXCESSIVE WELD REINFORCEMENT
INCOMPLETE PENETRATION&
EXCESSIVE PENETRATION
UNACCEPTABLEWELD PROFILES
Advantages of Welding Process over other Joining Processed
Disadvantages of Welding Process over other Joining Processed
Safety PrecautionsConcern Precaution / Remedy
Job PerformedJob Objective – Process Adopted –Tools & Equipments Used – Material Used – Procedure / Flow Chart –
(On the opposite to the write up of Job Performed, Exponential Diagrams to be drawn in line with the Process/step by step Procedure)
THANKS
top related