Welcome to FEMAP and NX Nastran v11.2 - Applied CAxappliedcax.com/.../Welcome-to-FEMAP-v11.2.2.pdf · Welcome to FEMAP and NX Nastran v11.2.2 A seminar for new FEMAP and NX Nastran
Post on 31-Jan-2018
271 Views
Preview:
Transcript
Welcome to FEMAP and NX Nastran v11.2.2A seminar for new FEMAP and NX Nastran users providing guidance in installation,
setup and running your first analyses.
Adrian Jensen, PE | Senior Staff Mechanical EngineerGeorge Laird PhD, PE | Principal Mechanical Engineer
September 23rd, 2015 Applied CAx Page 2
Installation
September 23rd, 2015 Applied CAx Page 5
September 23rd, 2015 Applied CAx Page 6
Licensing
September 23rd, 2015 Applied CAx Page 7
September 23rd, 2015 Applied CAx Page 8
Analysis Workflow:•Geometry•Material•Property•Mesh Sizing•Meshing•Constraints•Loads•Analyze•Post Process
Your First FEMAP Model
September 23rd, 2015 Applied CAx Page 9
GeometryFile > Import > Geometry
September 23rd, 2015 Applied CAx Page 10
MaterialsModel > Material > ISOTROPIC (7075‐T651)
September 23rd, 2015 Applied CAx Page 11
PropertiesModel > Property > PLATE (0.1”)
September 23rd, 2015 Applied CAx Page 12
Mesh SizingMesh > Mesh Control > Size on Surface
September 23rd, 2015 Applied CAx Page 13
MeshingMesh > Geometry > Surface
Custom Tools > Meshing > Spider Curves
September 23rd, 2015 Applied CAx Page 14
ConstraintsModel > Constraint > On SurfaceModel > Constraint > Nodal
September 23rd, 2015 Applied CAx Page 15
LoadsModel > Load > Nodal
September 23rd, 2015 Applied CAx Page 16
AnalyzeModel > Analysis (36..NX Nastran, 1..Static)
September 23rd, 2015 Applied CAx Page 17
Post ProcessingPost Processing Toolbox (Contour, Deform)
6700 North New York Avenue, Ste 231 Portland, OR 97203‐2836
800‐746‐8134appliedcax.com
Thank you!
top related