Texas Instruments TI-30Xa Battery Replacement · Texas Instruments TI-30Xa Battery Replacement This guide will show, step by step, the battery replacement for the TI-30Xa scientific
Post on 12-Apr-2018
307 Views
Preview:
Transcript
Texas Instruments TI-30Xa BatteryReplacement
This guide will show, step by step, the battery replacement for the TI-30Xa scientific calculator.
Written By: Chris L
Texas Instruments TI-30Xa Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5
INTRODUCTION
This guide will show, step by step, the battery replacement for the TI-30Xa scientific calculator.
TOOLS:Phillips #1 Screwdriver (1)
LR44 (A-76) Batteries (2)
Texas Instruments TI-30Xa Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5
Step 1 — TI-30XA Battery Replacement
Here's the fully assembled TI-30XAcalculator.
Step 2
Locate the six screws on the back of the calculator.
With a Phillips #1 screwdriver, loosen and remove the screws.
Texas Instruments TI-30Xa Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5
Step 3
Find the two notches at the top of the calculator.
Insert a flat-head screwdriver into one of the notches and carefully pry open the top end of thecase.
Locate where the case is still attached at the sides.
Insert the flat-head screwdriver into one side where the gap has widened.
Now gently pry apart the sides of the case.
Prying only one side will release the other side as well.
Step 4
Now separate the two panels fromone another.
Texas Instruments TI-30Xa Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-06-16 02:03:23 PM.
Step 5
The batteries are located at the top.
Slide the flat-head screwdriver underneath each battery and they will easily pop out.
Texas Instruments TI-30Xa Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5
top related