Transcript
A PRESENTATION ON
DISPLAYING IN LCD USING PROTEUS
GROUP MEMBERS
Name ID
1.Kandil Al Aksa 12131103054
2.Md. Omar Faruq 12131103065
3.Azharul Islam 12131103066
OBJECTIVES
To understand how to Display in LCD
How to use PIC-16F877 Micro-controller
How to use LM016L (16 X 2) LCD
SOFTWARE COMPONENTS
Proteus 8.0 Professional Simulator
MikroC Pro v-5.61
SIMULATING COMPONENTS
• Micro-Controller PIC16F877
• LCD Display (16X2) Model - LM016L
• POT-HG (Variable Resistor)
• GROUND
MICRO-CONTROLLER
•What is a microcontroller?
A microcontroller is a compact standalone computer, optimized for control applications. Entire processor, memory and the I/O interfaces .So it takes less time to read and write to external devices.
FEATURES OF PIC16F877A
• High-performance RISC (Reduced Instruction Set Computing) CPU
• Total 40 Pins , 33 I/O pins & 5 I/O ports.
• Flash memory:14.3KB(8192 words)
• Data SRAM:368 bytes
• Data EEPROM:256 bytes
• Operating speed:20Mhz, 200ns instruction cycle
• Operating voltage:4.0-5.5volts
MICRO-CONTROLLER MODEL - PIC16F877
REQUIREMENT OF PINS IN THIS SIMULATIONPin Name Pin Number I/O/P Type
RB0/INT 33 I/O
RB1 34 I/O
RB2 35 I/O
RB3/PGM 36 I/O
RB4 37 I/O
RB5 38 I/O
LCD DISPLAY(16X2) LM016L
LCD DISPLAY (16X2) LM016L PIN DESCRIPTIONPin Number Symbol Function
01 VSS GND
02 VDD + 3V or + 5V
03 VEE + 4.2V for LED Output
04 RS Register Select Signal
05 R/W Read/Write Signal
06 E Enable Signal
07-14 DB0-DB7 Data Bus Line
POT-HG VARIABLE RESISTOR
POT-HG is the only active variable resistor that allows you to change the resistance during simulation run-time
SIMULATION
MIKROC PRO(5.61) FOR PIC
• mikroC PRO for PIC is a full-featured ANSI C compiler for PIC devices from Microchip. It is the best solution for developing code for PIC devices. It features intuitive IDE (Integrated Device Electronics) , powerful compiler with advanced optimizations, lots of hardware and software libraries .
INSTALLATION OF MIKROC PRO FOR PIC
• Install this software just like other simple software .
CREATING A NEW PROJECT USING MIKROC
CLICK NEXT & GO TO THE NEXT STEP
SELECT DEVICE NAME ON WHICH YOU WORK THENCLICK NEXT & GO TO THE NEXT STEP
CLICK NEXT & GO TO THE NEXT STEP
CLICK NEXT & GO TO THE NEXT STEP
CLICK FINISH
THIS IS YOUR NEW PROJECT FILE
CODE IN MIKROC
DOUBLE CLICK ON PIC16F877 MICROCONTROLLER THEN SELECT PROJECT HEX FILE
FINALLY
THANK YOU
HAVE YOU ANY QUESTIONS ?
DROPBOX DOWNLOAD LINK
HTTPS://WWW.DROPBOX.COM/SH/PUGUAI4S7XWM876/AAAQR0FQT4J4OVDEZFOHA-48A?DL=0
top related