GE PROPRIETARY AND CONFIDENTIAL INFORMATION

THIRD ANGLE PROJECTION

1112131415161718

131415161718

D

C

B

D

C

B

11

ADigital EnergyMultilin

6.70[170,2]

3.10[78,7]

7.15[181,5]

7.55[191,8]

1.55[39,4]

9.90[251,3]

8.42[214]

8.84[224,4]

7.25[184,2]

9.00[228,6]

x8.1904,83[ ]

7.65[194,3]

GE PROPRIETARY AND CONFIDENTIAL INFORMATIONThis document is the property of General Electric Company ("GE") and contains proprietary information of GE. This document is loaned on the express condition

that neither it nor the information contained therein shall be disclosed to others without the express written consent of GE Industrial Systems, and that the information shall be used by the recipient only as approved expressly by

GE Industrial Systems. This document shall be returned to GE upon its request. This document may be subject to certain restrictions under

U.S. export control laws and regulations.

215 ANDERSON AVEMARKHAM, ON, CANADA, L6E 1B3 INTERNET: http://www.GEIndustrial.com/pm

TEL: (905)294-6222 FAX:(905)201-2098

8 SERIES UNITSIZE DRAWING REV

D 892455 A1-P1SCALE: 0.400 PART No: 18J0-XXXX SHEET 1 OF 1

SIZE DRAWING NO. REV SHEET

D 892455 A1-P1 1REVISIONS

REV. DATE ECO# DWN APP DESCRIPTION

CRITICAL TO QUALITYCHARACTERISTIC

. FINISH

. FRACTIONS

TOLERANCE ON:1 PL DECIMALS 0.02 PL DECIMALS 0.013 PL DECIMALS 0.005 ANGLES 1.0

UNLESS OTHERWISESPECIFIED IN DRAWING

DIMENSIONS ARE IN INCHES

.APPLIEDPRACTICES

FOR ADDITIONAL INFO REFER TO:

REFERENCE DRAWINGSDWG No.TITLE

SIGNATURES DATE

MODEL DU MAY 18 2012

DETAIL DD OCT. 23 2012

CHECKED NN OCT. 25 2012

WHERE USED:

, , DRAWING FILE: 892700-MANUALFILE LOCATION:

SOFTWARE TOOL: Pro/ENGINEER

ATTENTION: THIS DRAWING BASED ON '892455_UNIT' MODEL, WHITH SOME PARTS SUPRESSED. IN ORDER TO VIEW IT PROPERLY YOU SHOULD RESUME ARMS, HANDLE AND SCREWS IN FP ASSY; PANEL AND SCREWS IN CAPTIVE ASSY.

8-32X3/8" PAN HEADPHILIPS MACHINE SCREWGEPN 1408-0306 TYPX6APPLY TORQUE 15 IN*LB

STEP 1

SCALE 0.400

STEP 2

HANDLE TO BE LIFTED TO 90POSITION WHILE SLIDINGDRAW-OUT UNIT INTOCAPTIVE UNIT

STEP 3

MAINTAIN HANDLE LIFTED POSITIONUNTIL DRAW-OUT UNITIS FULLY INSERTED

STEP 4

PUSH HANDLE DOWN AND TIGHTEN THE SCREW.

HANDLE SHOULD BE FLUSH WITHFRONT PANEL SURFACE

PANEL CUT-OUT DIMENSIONSSCALE 0.500