ENERGY. Conservation of Energy: The total amount of energy in a system remains constant ("is conserved"), although energy within the system can be changed.

ENERGY

Conservation of Energy:

• The total amount of energy in a system remains constant ("is conserved"), although energy within the system can be changed from one form to another or transferred from one object to another. Energy cannot be created or destroyed, but it can be transformed.

Energy• Energy comes from the sun in the form of insolation.

• Insolation is INcoming SOLar radiATION

That energy is transferred by:

• Conduction

• Convection

• Radiation

• They may occur individually, or all three may occur at once.

Lets start with conduction• In conduction, energy is transferred between

substances by contact. • Energy is transferred from high to low.

Therefore, when areas of higher temperature come into physical contact with areas of lower temperature, heat energy will be transferred. The hot object will cool down and the cool object will heat up until equilibrium is reached.

• However; (there’s always a catch . . .) More heat is released from the warmer object than is gained by the cooler object. – some heat energy escapes into the surroundings during the process . . .

Examples of conduction:

On a cold day, warm air inside the house comes in contact will cool air outside and escapes from the house ~ that’s why we need insulation!

If an object is held in a flame (heat energy); the heat from the flame will travel down the object.

• In the atmosphere, heating by conduction is primarily important at the ground, where air warms by directly contacting the surface.  Sunlight has very little warming effect directly on air molecules.

Key Terms• Rate of Change: Change in field value over

time; i.e. ~ how much has changed over how much time.

• For example; If the temperature is 75o at 5:00 pm and 50o at 10:00pm, what would be the rate of change?

• 75o - 50o (Change in field value)

5 hours (time)

• Rate of Change = 5o/Hour

A few more key terms. . .• Calorimeter: Object used for measuring heat. (Heat can be

measured in ‘calories’, unrelated to dietetic calories.) A calorimeter can be a thermometer, or any object used to measure temperature.

• Potential Energy: Stored energy; higher temps mean higher potential energy.

• Kinetic Energy: Energy of motion; more/faster motion means higher kinetic energy.

Potential energy and kinetic energy are interchangeable – items at rest (potential) can move, items in motion (kinetic) can stop.

The rock contains potential energy; if it falls, it’s kinetic (and painful . . . )

Kinetic and Potential Energy in action via conduction:

• The stored heat energy (potential energy) on the left is being transferred to the cooler area on the right; once the heat is in motion, it becomes kinetic energy.

Now, how about convection:• Convection: The transfer of energy by circulation.

• Energy will circulate based on differences in density; generally speaking, the higher the temperature, the lower the density.

• Therefore;

higher temps tend to rise and lower temps tend to sink

Causing convective circulation

A few more key terms . . .• Fluid: A substance with moderate density that

flows easily and assumes the shape of its container.

• Earth’s Mantle: The portion of Earth between the crust and outer core.

Convection in liquids:

Warm liquid (less dense) rises, cool liquid (more dense) sinks; the motion creates convection cells and/or currents.

Convection in air:

The air above the blacktop is heated by the warm blacktop, causing the air to rise. The rising air is replaced by cooler air from over the meadow.

So, we can figure that . . .• Warm substances

(lower density) will rise when placed into cold substances

• Cold substances (higher density) will sink when placed in warm substances.

• Introducing heat causes density to decrease – thus air rises.

And, last, but not least . . .

Radiation~ it’s all about the waves . . .

• Radiation is the transfer of energy through space by waves.

• Not all radiation is the same, we receive and transmit radiation in a variety of ways.

Absorption & Radiation of Energy• Waves come in many shapes and sizes depending on a

myriad of factors.

• To keep it simple, short waves come from the sun and are absorbed by the Earth. The Earth processes the radiation (insolation) and re-radiates it back out as long waves.

• Absorption and radiation are dependent upon the type of surface the waves encounter.

• Dark rough surfaces absorb more, therefore re-radiate more.

• Whereas, light, smooth surfaces tend to reflect the waves and thus re-radiate much less.

Key Terms:• Absorption: To take

in/retain energy waves without reflecting.

• Black dirt, for example, will retain insolation like a sponge retains water.

But, there are two sides to everything. . .

• Reflection: To throw or send back from a surface.

• Water will reflect insolation like a mirror reflects an image.

• Re-radiation: To emit or send off after absorbing.

• The desert sand absorbs short-wave insolation all day, then re-radiates long waves back out.

• Radiative Balance: incoming = outgoing

• (insolation = re-radiation)

So . . .

• The rate at which energy is absorbed by a surface is determined by its color and texture.

• Dark, rough surfaces will absorb and re-radiate much more than light, smooth surfaces.

• Conduction: Transfer by contact

• Convection: Transfer by circulation

• Radiation: Transfer by waves

So; Now we know . . .We transmit heat energy via: