Transcript
Semi automatic machine the D150 and the 150M
The strong Points
Trade mark DUBUITA world wide known model D_150
5000 units solde world wideUnmatched Universality
Build for lasting some model manufactured in 1964 are still in use
Main feature
Level of the screen always constantPneumatic squeegeeLift of the screen through a parallelogram linkage
Main feature
Central cam fora) Lifting screenb) Screen stroke
Unmatched Universality
• Chnaging from falt to cylinder in less than 5 minutes
• In two clics
Unmatched Universality
Only four screws too loosen for changing from screen movement to squegee movement
Registration with a pointer for rigid cylinders
Object is fixed in the horizontal plane
Printing on plastic bottles between chuck and counter point with roller ware holders and inflating device
Printing on plastic bottles between chuck and counter point with roller ware holders and inflating device
The same with auto registration
Oval printing
Oval two side attachment
Oval two side attachment shift of the screen
Conical printing with special counterpoint
Registration on the side
of the bottle through electro magnet
Printing two colors
Printing two colors
Printing two colors
Printing two colors
Double stroke attachment
Registration for double or triple stroke
Triple stroke attachment
Triple stroke attachment:drive of the mandrel
Triple stroke attachment:drive of the screen
Conical for large object
Conical for large object
Long object device for burette ski poles etc..
Long object device for burette ski poles etc..
Printing flats
• In few minutes the machine can be turned to flat printing mode
• It can print on various objects but can also have its stroke increased to 600mm and even 700mm .
• The machine can be also dedicated to special applications like crate printing with or without automatic flip device to print on two opposite sides
Unmatched Universality
Flat printing possibilitiesUnmatched Universality
Standard flat support
When the machine stops the level of the screen is 70mm from the object (lift stroke)Therefore for each object it is necessary to set its height as the level of the screen in down position is always the same This setting is made through a hand wheel (Standard device on DFE machines)
Holders are specific to the object and made on demand
Flat bottle holder
Fholding device for flat plastic container
Double stroke attachment increasing the stroke to 600mm or 700mm
Impression de courroie à plat
Printing on chanpagne wooden box
Printing on crate one side
Printing on crate two sides
Two side printing device
Drive of the two side printing device for crates
Dwell screen drive
Dwell screen drive
Ensure a vertical lift at both ends of the stroke during 60° of the machine cycleDevice not manufactured in Thailand
Special device for printing four sides of an object
Printing of heavy container
• Possible because• The main frame is in cast iron versus
aluminium for the Chinese machine which give to the machine its strongness
• Because the object is fixed• It wide possibilities in term of length of the
stroke gives a wide variety of possibilities
Printing of heavy containers like gas bottle or fire extinguishers
Drive by the screenStrongly builtPrinting on heavy containers
Positioning in height and rotationStrongly builtPrinting on heavy containers
Screen driveStrongly builtPrinting on heavy containers
Chuck drive with sliding tableStrongly builtPrinting on heavy containers
Chuck drive by gear and rackStrongly builtPrinting on heavy containers
Drive through the rollers with sliding table
Strongly builtPrinting on heavy containers
The sliding table with driven rollersStrongly builtPrinting on heavy containers
Dirve of the rollerStrongly builtPrinting on heavy containers
Sliding table with longt object printing attachment with an increased stroke of
300mm
ROBUSTESSEIMPRESSION D’OBJETS LOURDS
Drive of the screenStrongly builtPrinting on heavy containers
Machine in working conditions Dryers
top related