Cutting Tension Meter - Bipicobipico.com/wp-content/uploads/2020/11/Tension-meter.pdf · 2020. 11. 28. · ii)Tension meter to be placed on the loose blade on machine. Ensure that
Post on 18-Mar-2021
6 Views
Preview:
Transcript
i) Wrong tension of band saw blades can cause for crooked cutting, getting cutting surface rough and blade breakage.
ii) Proper blade tension will keep blades in good fatigue life.
iii) Reduces occurance of machine damage due to band over tensioning
Parameters of Band Tension
Note : Band tension capabilities may vary by make and model of the band saw machine.Machine manufacturer or technician can help if there is any issue concerning machine band tension techniques or capabilities.
506/A, Lotus House, 5th Floor,33, Sir V. Thackersey Road, Next to Liberty Cinema, Mumbai – 400 020, IndiaTel : (022) 22003881 / 22035519 / 22000747; Fax : (022) 22001631Email : mumbai@bipicoexp.com /
Nadarkha , Post Box No.36 , Bilimora – 396321,Gujarat. ( India )+91 (2634) 284629 , 283695 , Fax 283256Email :Sales@bipicoexp.com, info@bipicoexp.com
Bipico Industries (Tools) Pvt. Ltd.Registered & corporate office
Factory
Website : www.bipico.com
ii)Tension meter to be placed on the loose blade on machine. Ensure that tension meters is fixed parallelly by keeping approximate 5 mm distance between the back of the blade & tension meter slot.
arms are closer to each other, lower tension range to be used.
dial is 1 division = 1000 PSI. Adjust the tension on blade until desired tension & reading is obtained.
19mm ,27mm and 34mm Wide Bimetal Band saw : 30000 to 38000 PSI25000 to 30000 PSI
41mm and above Bimetal Band saw :
iii) Tighten the left side thumb screw & then after right side thumb screw of moving arm on tension meter.
iv) Set the dial ring to Zero position & start tightening the blade manually or by hydraulic pressure
vi) When you start giving tension on the blade, the dial will start showing reading on scale. The scale on
Why to use Tension Meter ?
Therefore, the band tension should be checked frequently as per below given instructions.
i) Fix the Bimetal Band Saw blade on the machine.
Instructions of using Tension Meter
v) As a general thumb rule, when the guides are more apart, the higher tension range to be used & when guides
Tension Meter
R
Cutting… Leave it to us
top related