Chapter: Earth’s Changing Surface

Chapter: Earth’s Changing Surface

Table of Contents

Section 2: Shaping the Landscape

Section 1: Weathering and Soil

Section 3: Groundwater

Section 4: Geologic Time

• Weathering is an example of physical and chemical processes that involve the interaction of air, water, and rock over time.

• Weathering is the process of physical or chemical breakdown of a material at or near Earth’s surface.

WeatheringWeathering and Soil

1

• Factors that influence weathering include the agent, such as water or air, the nature of the material being weathered, climate, and time.

• Forces that can cause mechanical weathering include impact, expansion or contraction of materials, and biological effects.

• Variables that control mechanical weathering include the nature of the material being weathered, climate, and time. Of these variables, time is the least noticeable.

Mechanical WeatheringWeathering and Soil

1

• When water freezes, it expands. This forces the cracks apart and ultimately forces the rock apart.

• This type of weathering is called frost wedging.

Prying Rock ApartWeathering and Soil

1

• The figure illustrates what happens when a large object breaks apart.

Prying Rock ApartWeathering and Soil

1

• Rocks can also act as impact agents.

• As a large particle breaks into smaller particles, the amount of surface area increases. More surface area compared to volume increases the likelihood that a material will be attacked by chemical agents.

Prying Rock ApartWeathering and Soil

1

• The process of chemical weathering forms new compounds and releases elements into the environment.

• Water and oxygen are the key agents of chemical weathering, along with naturally occurring acids.

Chemical WeatheringWeathering and Soil

1

• Soil is a mixture of weathered rock, organic matter, water, and air that is capable of supporting plant life.

• Soil originates from weathering of the bedrock beneath it or from materials transported from another location.

SoilWeathering and Soil

1

• The figure shows a complete set of horizons, designated as O, A, E, B, C, and R from the surface to bedrock.

• The O horizon, for organic, and the A horizon often are referred to as topsoil.

Soil HorizonsWeathering and Soil

1

• The E horizon is a zone in which finer sediments and soluble materials are transported downward.

• The B horizon collects the materials from above and is usually darker than the E horizon.

Soil HorizonsWeathering and Soil

1

• The C horizon is partially crumbled and weathered bedrock. The R horizon is unweathered bedrock.

Soil HorizonsWeathering and Soil

1

• Climate often is used as a basis to characterize many different types of soil.

Soil TypesWeathering and Soil

1

Soil TypesWeathering and Soil

1

• They are separated according to composition and physical properties.

• The amount of precipitation and the temperature range of a region, together with the type of parent material, affect the soil that forms.

• Soil depletion is a serious agricultural problem in many regions.

Soil ConservationWeathering and Soil

1

• Soil depletion is most often corrected by the addition of fertilizers containing nitrogen, phosphorous, or potassium.

• Most soil lost to erosion occurs because the vegetative cover has been removed or because the land is overly steep.

Section Check

1Question 1

Which is NOT an agent of mechanical weathering?

A. contractionB. expansionC. impactD. oxygen

Section Check

1Answer

The answer is D. Oxygen is an agent of chemical weathering.

Section Check

1Question 2

Which mineral, present in rocks, turns a brownish-red color?

A. calciteB. feldsparC. hematiteD. silicon

1Section Check

Answer

The answer is C. Hematite is often mined to obtain iron for steel production.

Section Check

1Question 3

Which horizons combine to form topsoil?

A. A and OB. E and HC. B and CD. C and R

1Section Check

Answer

The answer is A. Plants get most of their nutrients from topsoil.

Shaping the Landscape

2

• Erosion is the removal of surface material through the process of weathering.

Erosion, Transport, and Deposition

• Sediment transport is the movement of eroded materials from one place to another by water, wind, and/or glaciers.

• When a transporting agent drops its load of eroded material, deposition occurs.

Shaping the Landscape

2

• An important agent of erosion that exerts a downward force on slopes is running water.

Running Water

• In most river systems, small streams called tributaries flow into larger streams, which in turn flow into even larger streams.

Drainage Basins

• All of the land area that gathers water for a major river is the river’s drainage basin.

Shaping the Landscape

2

• As surface water flows downhill under the influence of gravity, water erodes the surface, creating its own path or following existing paths called channels.

Channel Development

• When running water slows down, it drops part of the sediment load it is carrying, largest particles first.

Stream Deposits

Shaping the Landscape

2

• Floodplains are part of a river, but they are only submerged during floods.

Floodplains

• As the mouth of a stream that empties into a body of water, a fan-shaped sediment deposit called a delta will form.

Deltas

Shaping the Landscape

2

• Valley glaciers form at the top, or head, of river valleys in mountainous regions. They move down slope, usually following the path of the preexisting valleys.

Glaciers

• Continental glaciers, which occupy huge land areas, cover all but the highest peaks. Ice moves away in all directions from where it accumulates.

Shaping the Landscape

2

• Glaciers become effective agents of erosion as they move either down slope as in valley glaciers or under their own weight as in continental glaciers.

Glaciers

Shaping the Landscape

2

• Valley and continental glaciers leave behind deep grooves or striations, which give clues about the direction the ice was moving.

Erosional Features

• Glacial ice exerts pressure to the sides as well creating the distinct and easily recognized U-shaped valley.

Shaping the Landscape

2

• Till is composed of random sediment sizes ranging from tiny clay particles to house-sized boulders.

Glacier Deposits

• The large ridges of till that accumulate at the edge of a glacier are called moraines.

Shaping the Landscape

2 Wind

• As wind velocity decreases, the load of sediment is dropped.

Wind Deposits

• The shapes and sizes of landforms that form depend on how constant the wind velocity is and on the supply of sediment.

Erosion by Wind• The removal of small particles by wind,

leaving heavier particles behind is called deflation.

Shaping the Landscape

2

• Longshore current occurs when waves approach a shoreline at an angle and are refracted.

Wave Action

• The backwash returns to the sea perpendicular to the shoreline.

Shaping the Landscape

2

• Longshore currents move sediment along the shore.

Deposition by Wave Action

• Where this current slows, sediments are deposited as offshore sand ridges or bars.

• Sandbars run parallel to the shore.• Spits are sand bars that project into the

water from land and curve back toward land in a hook shape.

Shaping the Landscape

2

• Mass wasting occurs when erosion occurs primarily as a result of gravity, whether triggered by an influx of water, by earthquakes, or by human activity.

Mass Wasting

• Wasting erosion caused by mass wasting is dependent upon the type of event and the type of materials involved: slumps, landslides, rockslides, or mudflows.

• Mass wasting events tend to dump their material in disorganized masses.

2Question 1

_______ is the removal of surface material through the process of weathering.

A. DepositionB. ErosionC. SedimentD. Transport

Section Check

2Answer

The answer is B, erosion.

Section Check

2Question 2

_______ form when wind moves sand-sized particles into distinct forms.

A. CirquesB. DunesC. GlaciersD. Waves

Section Check

2 Answer

The answer is B. The shapes and sizes of dunes that form depend on how constant the wind velocity and on the supply of sediment.

Section Check

2Question 3

Bowl-shaped basins called _______ form by erosion at the start of a valley glacier.

A. arêtesB. bowlsC. cirquesD. horns

Section Check

2Answer

The answer is C. Valley glaciers form at the head of a river valley in mountainous regions.

Section Check

The Water Cycle• Freshwater supplies are constantly being

replenished through the water cycle.

Groundwater

3

• A lesser amount enters the cycle through transpiration.

• The energy to power both evaporation and transpiration comes from the Sun.

enters Earth to become groundwater below the surface.

• Infiltration is the process by which water

The Water Cycle

Groundwater

3

Groundwater• The region near the surface where water

can infiltrate freely is the unsaturated zone.

Groundwater

3

• The region below that is the saturated zone.

• The water table is the boundary separating these two zones.

Groundwater Storage• A rock unit that can transmit water through

its pore space is called an aquifer.

Groundwater

3

• A rock that slows or stops infiltration is an aquitard.

Porosity and Permeability• The combined volume of these shapes

defines the material’s porosity.

Groundwater

3

• Permeability is a measure of how well a fluid can pass through a material.

Water Resources

• Wells are holes dug or drilled into Earth.

Groundwater

3

• Much like surface water, groundwater flows downhill.

Obtaining Groundwater

Pollution and Groundwater Resources

Groundwater

3

• Pollutants that are spilled or dumped onthe ground enter groundwater through infiltration, as shown.

Section Check

Question 1

What is illustrated in this figure?

A. carbon cycleB. nitrogen cycleC. oxygen cycleD. water cycle

3

Section Check

Answer

The answer is D. The water cycle continually redistributes Earth’s water.

3

Section Check

Question 2

What is an artesian well?

3

Answer

Wells drilled into aquifers that are under sufficient natural pressure to force water up into a well are called artesian wells.

Section Check

Question 3

Which is not formed as a result of groundwater?

3

A. cavesB. sinkholesC. springsD. wells

Section Check

Answer

The answer is D. Wells contain groundwater but they are man-made structures.

3

Time

• Absolute dating is the process of assigning a precise numerical age to an organism, object, or event.

• Relative dating is the process of placing objects or events in their proper sequence in time.

Geologic Time

4

Absolute and Relative Dating

Uniformitarianism• Uniformitarianism states that the laws

of nature operate today as they have in the past.

• The only changes might be in their rate or scale.

Geologic Time

4

Principles of Relative Dating• Principle of superposition states that

the oldest rocks in an undisturbed sequence of rock layers will be at the bottom of the sequence.

• Sedimentary layers always start off as horizontal layers.

Geologic Time

4

Original Horizontality

• The principle of cross cutting relationships. states that any rock formation or fault is younger than the rock or feature that it cuts through.

Overlapping Features

Geologic Time

4

Unconformities

deposition was absent.

• Unconformities represent gaps in the rock record during which erosion occurred or

Geologic Time

4

• A disconformity is an erosional surface between horizontal rock layers.

Unconformities

Geologic Time

4

• A nonconformity is an erosional surface between sedimentary rock and igneous or metamorphic rock.

• An angular unconformity is an erosional surface between rock layer segments that intercept at an angle.

Fossils• The remains or traces of organisms found in

the geologic rock record are called fossils.

Geologic Time

4

• The process of matching distinctive rock units from different regions is called correlation.

Correlation

Geologic Time Scale• Paleontologists observe

changes in the fossil record and associate them with boundaries of time units.

Geologic Time

4

• At these boundaries, fossils of certain life forms are no longer present and new life forms begin to appear.

Absolute Dating

• Some types of atoms are unstable and decay by casting off, or emitting, parts of their nuclei.

Geologic Time

4

Radioactive Decay

• The half-life is the time it takes for one-half of a radioactive parent sample to decay to its stable daughter.

Geologic Maps• Geologic cross-sections represent a

vertical slice taken through Earth.

Geologic Time

4

• Geologic maps show the horizontal surface distribution of various rock formations.

Basins and Domes• The principle of original

horizontality states that sediments are laid down in horizontal layers.

Geologic Time

4

• Compressional forces cause the layers to fold and to dip downward.

Basins and Domes

Geologic Time

4

• In basins, the youngest rocks are exposed in the center and tilt or dip inward.

• Domes are essentially the opposite of basins.

Folds• Folding of the crust can also be recognized

on geologic maps.

Geologic Time

4

• An upward wrinkle of rock formations is an anticline and a downward wrinkle is a syncline.

wrinkle up or fold. • Rocks subjected to the compression might

Plunging Folds

Geologic Time

4

• If the forces are applied unevenly the axis of the fold might plunge back into theEarth, producing a surface pattern of rock like the one shown in the figure.

Section Check

Question 1

_______ is the process of placing objects or events in their proper sequence in time.

A. Relative datingB. Absolute datingC. Carbon datingD. Fossil dating

4

Section Check

Answer

The answer is A. When you date events relatively, you know which came first, second, and so on.

4

Section Check

Question 2

Why is Fossil C considered to be between 2.1 and 2.4 million years old?

4

Section Check

Answer

You could conclude from the rock layers at Location A that Fossil C is between 2.1 and 2.4 million years old, Fossil A is older than 2.4 million years, and Fossil E is younger than 2.1 million years.

4

Section Check

Question 3

Which time unit of the geological time scale is the shortest?

A. eonB. epochC. periodD. era

4

Section Check

Answer

The answer is B. An epoch is the shortest time unit of the geological time scale.

4

To advance to the next item or next page click on any of the following keys: mouse, space bar, enter, down or forward arrow.

Click on this icon to return to the table of contents.

Click on this icon to return to the previous slide.

Click on this icon to move to the next slide.

Click on this icon to open the resources file.

Help

Click on this icon to go to the end of the presentation.

End of Chapter Summary File