Top Banner
Sri Sresti Marketing Solutions 16-3-32/C, Kowtha Street, Purnanandampet, VIJAYAWADA – 520 003. Andhra Pradesh. INDIA. Email: [email protected] www.srisms.com Phone: 9014110759 / 9247110759 (Image courtesy by: Mr. Potla Uma Sankara Maheswara Rao, S/o Nagaraju, Sankaram Colony, Rebaka post, ANAKAPALLE, Visakha Dist., Andhra Pradesh - 531001, Ph: 9000825206) Gap between panels is about one inch to reduce air lift in situations of stormy weather and cyclone affect. This one inch air gap will reduce extensive damage to panels and also gives safety to nearby people / property.
12

Solar.panel.mounting.structure.design

May 20, 2015

Download

Self Improvement

solarkit

Gives design particulars / information on setting up solar panels for roof top applications.
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Page 1: Solar.panel.mounting.structure.design

Sri Sresti Marketing Solutions 16-3-32/C, Kowtha Street, Purnanandampet,

VIJAYAWADA – 520 003. Andhra Pradesh. INDIA. Email: [email protected] www.srisms.com

Phone: 9014110759 / 9247110759 (Image courtesy by: Mr. Potla Uma Sankara Maheswara Rao, S/o Nagaraju, Sankaram Colony,

Rebaka post, ANAKAPALLE, Visakha Dist., Andhra Pradesh - 531001, Ph: 9000825206)

Gap between panels is about one inch to reduce air lift in situations of stormy weather and cyclone

affect. This one inch air gap will reduce extensive damage to panels and also gives safety to nearby

people / property.

Page 2: Solar.panel.mounting.structure.design
Page 3: Solar.panel.mounting.structure.design
Page 4: Solar.panel.mounting.structure.design

Holes at the bottom side to drain off rain water

Page 5: Solar.panel.mounting.structure.design
Page 6: Solar.panel.mounting.structure.design
Page 7: Solar.panel.mounting.structure.design
Page 8: Solar.panel.mounting.structure.design
Page 9: Solar.panel.mounting.structure.design
Page 10: Solar.panel.mounting.structure.design

It is

always suggested to use branded battery especially for solar applications than other type of battery as

they may not last long. Depending upon load type you can choose C10 (for induction / motor load) or

C20 (for tube lights / fans / LCD / LED Tv etc) variety.

Page 11: Solar.panel.mounting.structure.design

This side is 23inches height

This side is 12 inches height. Angle comes to about 23degrees. Panels should face south direction. See

that the panels receive abundant sunlight without any shadows at any time.

Page 12: Solar.panel.mounting.structure.design