REYNOLDS-FRENCH & COMPANY 12525 E. 60th Street Tulsa, OK. 74146-6921 (918) 252-7545 Fax: (918) 252-7540 [email protected].

REYNOLDS-FRENCH & COMPANY12525 E. 60th Street

Tulsa, OK. 74146-6921(918) 252-7545 Fax: (918) 252-7540

[email protected]

Cat 992G 17 cu. ft. Loader taking material to Shaker/ Separator / Crusher

42” Taylor Gyro Crusher This unit was damaged when the turning bell bound up, cracking the case

Shaker / Separator Conveyor belt feed approx. 3/4 mile long with blasted raw material

6” dia. to 2 cu. ft. material to be supplied to crusher

Special tools being setup at work area

Milling for locking devices on top flange Casting 7” thick

Crack on underside of top flange The 26” long crack has gapped 1/4” to 5/16” wide

Top flange has been machined to accept 3 sets (6 locks) ranging from 8” to 22” long & 2” to 6 1/2” wide & 1 1/2” thick

Exterior metal locking on 36” of crack on upper flange

18 ft. dia. shrink ring prefabricated in Reynolds-French shop ready to lift (Two used)

Shrink ring being positioned on top of crusher approx. 40 feet high

Top shrink ring being lowered in place

Note the tapped holes in the steel ring where jack bolts will be torqued after positioning ring

This shows both steel shrink rings installed to take seismic loadingNote cap over jack bolts torqued so bolts will not back off during vibration of operation

Locks installed on top surface & crack repaired with 1 1/8” stitching bolts Chockfast Orange poured between ring and casting

8” locks, 2” thick on exterior and cracks stitched with 9/16” bolts Note all materials were furnished by Reynolds-French

REYNOLDS-FRENCH & COMPANY12525 E. 60th Street

Tulsa, OK. 74146-6921(918) 252-7545 Fax: (918) 252-7540

[email protected]