Prevention of Water Damage to Steam Turbines Used for Electric Power Generation: Fossil-Fuel Plants Standards for Engineers Worldwide ASME TDP – 2013 ASME’s TDP-1 Standard provides recommended practices for the prevention of water damage to steam turbines used in fossil-fuel- ﬁred electrical power generation. These practices address damage due to water, wet steam, and steam backﬂow into a steam turbine and are applicable to conventional steam cycle, combined cycle and cogeneration plants. They cover design, operation, inspection, testing, and maintenance of those aspects of the following power plant systems and equipment concerned with preventing the induction of water into steam turbines and associated systems and equipment: Order Today: Phone: 1.800.843.2763 Fax: 1.973.882.8113 Email: email@example.com Web: http://www.asme.org/kb/standards ASME TDP-1-2013 Standard on Prevention of Water Damage to Steam Turbines Used for Electric Power Generation: Fossil-Fuel Plants ISBN: 9780791868607 No. Pages: 36 Digital Download (PDF) / Order No.: K0661Q Print-Book / Order No.: K06613 ASME Codes and Standards ASME is the leading international developer of codes and standards associated with the art, science, and practice of mechanical engineering. From the ﬁrst issuance of its legendary Boiler & Pressure Vessel Code in 1914, ASME’s codes and standards have grown to nearly 550 offerings currently in print. To learn more, visit www.asme.org/kb/standards/standards To volunteer on an ASME committee, visit go.asme.org/ParticipateInStandards • motive steam systems; • steam attemperation systems; • turbine extraction/ admission systems; • feedwater heaters; • turbine drain systems; • turbine steam seal systems; • turbine steam seal systems; • start-up systems; • condenser steam and water dumps; • steam generator sources. Intended for anyone engaged in the safety of steam turbines and fossil fuel power plants, including those responsible for: design, engineering and manufacture; operation, testing, maintenance, and monitoring; inspection and regulation; insurance and liability; facilities and plant management; and emergency response. • inclusion of mandatory language throughout document; • requirements for power- operated block valve closures; • parameters for feedwater heater testing; • considerations for vertical ﬂash tanks; • requirements for continuous drains; • requiremenrs for spray control valves and attemperator block valves; • requirements for feedwater block valve backﬂow; • addition of section on control systems and instrumentation; • addition of section on excess steam routed to feedwater heater or condenser. Key changes to this revision include… This is a preview of "ASME TDP-1-2013". Click here to purchase the full version from the ANSI store.