Multiconn Multiconn Srl Srl BMW - iDRIVE Professional Navigation CIC (7 buttons) BMW - iDRIVE Professional Navigation CIC (7 buttons) www.dasdvbt.com www.dasdvbt.com Installation and User Manual Installation and User Manual ver.1.0 ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user manual of DAS M32/M44] Fiber Optic Fiber Optic
10
Embed
Multiconn Srl BMW - iDRIVE Professional Navigation CIC (7 buttons) Installation and User Manual ver.1.0 [to integrate with the user manual.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Multiconn SrlMulticonn Srl
BMW - iDRIVE Professional Navigation CIC (7 buttons)BMW - iDRIVE Professional Navigation CIC (7 buttons)
www.dasdvbt.comwww.dasdvbt.com
Installation and User Manual Installation and User Manual ver.1.0ver.1.0 [to integrate with the user manual of DAS M32/M44][to integrate with the user manual of DAS M32/M44]
Fiber OpticFiber Optic
Multiconn SrlMulticonn Srl 2
BMW – CIC systemBMW – CIC system
Installation:Installation:
WARNING:WARNING: before installing the DASbefore installing the DAS®® tuner verify that the system of the car MUST be professional and not tuner verify that the system of the car MUST be professional and not Business. With Business system the TV tuner does not work.Business. With Business system the TV tuner does not work.To unlock the system use an interface or contact directly an official BMW center.To unlock the system use an interface or contact directly an official BMW center.
1. To install the DASDAS®® receiver, refer to the specific user manual;
Pay attention on the connection of the power supply cablePay attention on the connection of the power supply cable::
- RED wire (fig.3) must be RED wire (fig.3) must be DISCONNECTEDDISCONNECTED.. The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activityThe switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity
- YELLOW wire (fig.1)(fig.1) must be connected to the +12V permanent/battery- BLACK wire (fig.2)(fig.2) must be connected to the GND.
Power supply cable
11
22
33
2. Disconnect the original Fiber Optical cable (fig.4)(fig.4) from one of the original multimedia accessories inside the car (DVD, GPS, Amplifier, etc…) and match it directly to DASDAS®® fiber optic female connector of the harness on equipment (fig.5)(fig.5).
44 44 55
3. Match the two other connectors of DASDAS®® harness (fig.6)(fig.6) respectively inside the original accessory (fig.7)(fig.7) and the other one inside DASDAS®® receiver (fig.8)(fig.8).
Multiconn SrlMulticonn Srl 3
7777 88
66
55
88
99
88
99
4. Connect one of the 3 DASDAS®® Video-OUT (fig.8)(fig.8) trough the adapter cables on equipment (fig.9) and the needed accessory (fig.9) and the needed accessory with white Fakra connector (DCABMQS-RCA in fig.9.1) (DCABMQS-RCA in fig.9.1) with the Video-IN on the CICCIC Unit (fig.10)(fig.10).
99.1.1
BMW – CIC systemBMW – CIC system
DASDAS Video-OUT
Video-IN
Multiconn SrlMulticonn Srl 4
The CICCIC unit rear side view (fig.10)(fig.10)
1010
99.1.1
Insert the 2 female crimped pins of DASDAS cable (fig.9.1 fig.9.1 DCABMQS-RCA) inside the black 12P housing and then in white Fakra cover.If the connectors are already available in the unit, just connect the pins in the pin-out position recommended below.
Insert the wire with label ++ in pin 2pin 2 (positive signal).
Insert the wire with label -- inside the pin 12pin 12 (negative signal).If the pin 2 and 12 are already used by the rear camera, disconnect them and and connect to a yellow RCA to video-IN 1 on DASDAS receiver.
To shift automatically the signal from TV to REAR CAMERA, connect the green To shift automatically the signal from TV to REAR CAMERA, connect the green wire of the power supply cable (refer to the wire of the power supply cable (refer to the DAS DAS user manual) directly to the rear user manual) directly to the rear camera installed inside the vehicle.camera installed inside the vehicle.
BMW – CIC systemBMW – CIC system
Multiconn SrlMulticonn Srl 5
To enter in DASDAS TV tuner with the iDrive press MENU MENU, then CD/MultimediaCD/Multimedia and select TVTV (like the original TV Tuner).
WARNING:WARNING: For the basic settings such as color, contrast, brightness and format, please refer to the menu of the For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car and make sure that the format is congruent with the set menu on the DAS.car and make sure that the format is congruent with the set menu on the DAS.
CIC iDrive controllerCIC iDrive controller
Right rotation = UPon remote control (dropdown menu)
Left rotation = Down on remote control (dropdown menu)
BMW – CIC systemBMW – CIC system
User Manual:User Manual:
Multiconn SrlMulticonn Srl 6
To view the TV in full screen mode push the iDrive and select SplitscreenSplitscreen mode.
Next ChannelNext Channel(RIGHT)(RIGHT)
Previous ChannelPrevious Channel(LEFT)(LEFT)
BMW – CIC systemBMW – CIC system
Multiconn SrlMulticonn Srl 7
Remote Control Functions:Remote Control Functions: