Manual of Mini 3G Wireless Router

1. Product Specifications

Access mode

3G wireless access (WCDMA/EVDO/ TD-SCDMA)

Wired bandwidth PPPOE, dynamic DHCP, static IP

access

WiFi

Support IEEE802.11b/g/n,IEEE802.3/802.3u

WiFi maximum bandwidth access: 150Mbps

Support 30 WiFi clients access

Support WEP, WPA-PSK, WPA2-PSK wireless

encryption mode

WiFi WDS

(WiFi Distributed

Systems)

Support Bridge mode

Support Repeater mode

Support Lazy mode

Firewall

Based on MAC address/IP address/Port filtering

URL filtering

Web page keyword filtering

Dos Attack Prevention

Anti-ping function

Support the allocation of addresses up to 127

Network application

Application Layer Gateway ALG penetration

Virtual Server

Port triggering

Support UPnP

Support DMZ

Support DDNS

Traffic Management

Management of upstream and downstream flow rates

Support based on IP / MAC address bandwidth

management

Support protocol, port bandwidth management

Interface

1 10/100Mbps LAN/WAN Ethernet port

1 USB2.0 interface (3G network card interface)

1 mini USB charger interface

Battery 1500mAH; endurance is 3-5 hours

Size L 108mm * W 65mm * H 25mm

2. Product Description

POWER

INPUT

RJ45

LED Description

LED Description LED status Memo

Power LED:

Blue Light System Run, normal battery power

Red Light System Run, battery power is not normal

Battery

Charging

Blue Light Charging Finish, or battery full charge

Red Light Under battery power, charging

Network

Access LED

Blue Light Successfully connected to the Internet

Blue Flash Connecting to the Internet

Blue Slow Flash Not connected to the Internet

Wi-Fi LED

Blue Light WIFI Run

Blue Flash WIFI Data transfer

LED off WIFI Disable

WAN/LAN

LED

Blue Light Success of the wired network link

Blue Flash Cable network data transmission

3. PC Configuration

Before setting up the 3G Router, please make sure your PC is configured to “Obtain an IP

address automatically”.

For Windows XP/2000:

Click “Start”->”Control Panel” to open the windows control panel.

Open the “Internet Protocol (TCP/IP) Properties” window.

Select “Obtain an IP address automatically” and “Obtain DNS server address

automatically”. Then click OK.

For Windows Vista / Windows 7:

Go to “Start”->”Setting”->”Control Panel” to open the windows control panel.

Open the “Internet Protocol (TCP/IP) Properties” window.

Select “Obtain an IP address automatically” and “Obtain DNS server address

automatically”. Then click OK.

4. Router Configuration

1. Open your browser, type in 192.168.1.1, press “Enter”, then enter the username and

password (default setting is admin/admin) and click OK.

2. The web page will display when you log in successfully. Click “Wizard” item, enter the

new password then click Next.

3. Select your Time Zone, then click Next.

4. Select your Internet connection type. We select 3G Mode for example.

5. Click “Operator Info”, select the ISP information in the pop up windows then closed it,

click Next for continue.

6. Keep the default LAN settings and click Next to continue. Or you can type the new LAN IP

address and DHCP server IP pool.

7. Type the new SSID in the new window, then click Next to continue.

8. Enter the wireless Security Password to protect your wireless connection and prevent

the unauthenticated user to connect to your 3G Router. Then Click Finish, the 3G Router

will reboot.