Top Banner

Click here to load reader

Instalacion Flexi en Fcoa

Nov 08, 2014

ReportDownload

Documents

471449A 101 Nokia Flexi WCDMA Base Station, Rel. Flexi WBTS3.2, Product Documentation

Installing Flexi Cabinet for Outdoor

DN7062824 Issue 2 en

# Nokia Corporation

1 (107)

Installing Flexi Cabinet for Outdoor

The information in this document is subject to change without notice and describes only the product defined in the introduction of this documentation. This document is intended for the use of Nokia's customers only for the purposes of the agreement under which the document is submitted, and no part of it may be reproduced or transmitted in any form or means without the prior written permission of Nokia. The document has been prepared to be used by professional and properly trained personnel, and the customer assumes full responsibility when using it. Nokia welcomes customer comments as part of the process of continuous development and improvement of the documentation. The information or statements given in this document concerning the suitability, capacity, or performance of the mentioned hardware or software products cannot be considered binding but shall be defined in the agreement made between Nokia and the customer. However, Nokia has made all reasonable efforts to ensure that the instructions contained in the document are adequate and free of material errors and omissions. Nokia will, if necessary, explain issues which may not be covered by the document. Nokia's liability for any errors in the document is limited to the documentary correction of errors. NOKIA WILL NOT BE RESPONSIBLE IN ANY EVENT FOR ERRORS IN THIS DOCUMENT OR FOR ANY DAMAGES, INCIDENTAL OR CONSEQUENTIAL (INCLUDING MONETARY LOSSES), that might arise from the use of this document or the information in it. This document and the product it describes are considered protected by copyright according to the applicable laws. NOKIA logo is a registered trademark of Nokia Corporation. Other product names mentioned in this document may be trademarks of their respective companies, and they are mentioned for identification purposes only. Copyright Nokia Corporation 2006. All rights reserved.

2 (107)

# Nokia Corporation

DN7062824 Issue 2 en

Contents

ContentsContents 3 1 2 3 4 4.1 4.2 4.3 5 5.1 5.2 6 7 8 8.1 8.2 8.3 8.4 8.4.1 8.4.2 8.4.3 8.4.4 8.4.5 8.4.6 8.5 9 9.1 9.2 10 Overview of installing FCOA 5

Removing the FCOA cabinet roof 7 Lifting the FCOA 9 Installing the cabinet 13 Anchoring the FCOA 13 Changing the opening direction of the FCOA door Installing the FCOA security lock 31

17

Routing cabinet external cabling of FCOA 37 Routing the cables through FCOA cabinet bottom 37 Routing the cables through FCOA cabinet roof 39 Grounding the FCOA 43 Installing modules inside an outdoor cabinet 47 Installing options 53 Installing Flexi Power Module (FPMA) inside an outdoor cabinet Installing air filter 54 Installing Flexi System External Alarm (FSEA) 62 Installing battery backup solutions 66 Disassembling the rack 66 Installing batteries 68 Installing PDU and site support module 76 Installing the rectifier units (WPMB/WPMC) 94 Changing the alarm polarity of the WPUB unit 96 Changing the alarm polarity of the WPUC unit 100 Installing fire detector 102 Installation tools and torque values 105 FCOA installation tools and equipment 105 Torque values 106 Checklist for installing FCOA 107 53

DN7062824 Issue 2 en

# Nokia Corporation

3 (107)

Installing Flexi Cabinet for Outdoor

4 (107)

# Nokia Corporation

DN7062824 Issue 2 en

Overview of installing FCOA

1

Overview of installing FCOAPurpose

This section describes the overview of the Nokia Flexi Cabinet for Outdoor (FCOA) installation process.

Steps1. Check that the site meets the installation requirements. For further information, see Requirements for Installation and Operation. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Locate the site pack in the bottom right corner of the cabinet. Remove the cabinet roof. If required, lift the cabinet to the installation location. Anchor the cabinet on the base. Change the door opening direction, if needed. Install the security lock, if needed. Prepare the cabinet cable entries. Route the grounding cable and ground the cabinet. Install the optional air filter (FCFA). Install the Flexi System External Alarm (FSEA), if needed. Install the Flexi System External OVP (FSEC), if needed. Install the optional site support module (FCSA) and IBBU. Install the optional fire detector (FCDA).

DN7062824 Issue 2 en

# Nokia Corporation

5 (107)

Installing Flexi Cabinet for Outdoor

15.

Install the modules inside the cabinet.

16. 17. 18.

Route the cables in the cabinet and seal the cable entries. Install the roof. Connect the cables. For more information on cabling, see Cabling the BTS and Creating Configurations.

6 (107)

# Nokia Corporation

DN7062824 Issue 2 en

Removing the FCOA cabinet roof

2

Removing the FCOA cabinet roofPurpose

The cabinet roof is removed for certain tasks, such as lifting the cabinet, routing the cabinet external cabling through the roof, installing the air filter, changing the door handedness, or installing the Flexi System External Alarm or Flexi System External OVP.

DN7062824 Issue 2 en

# Nokia Corporation

7 (107)

Installing Flexi Cabinet for Outdoor

Summary

2

1

3

Back

DN7068496

Figure 1.

Removing the cabinet roof

Steps1. 2. 3. Open the door. Remove the screws behind the front plate. Remove the roof.

8 (107)

# Nokia Corporation

DN7062824 Issue 2 en

Lifting the FCOA

3

Lifting the FCOAPurpose

Follow these instructions when the cabinet must be lifted to the desired installation location. An empty cabinet weighs max. 80 kg. It can be lifted by a sufficient number of personnel using the lifting handles (WLHA lifting handle LEKA Kit 469554A). Lifting eye bolts are not included in the delivery. They can be ordered separately (LEKA Kit 466289A). A fully equipped cabinet can be lifted with a crane.

DN7062824 Issue 2 en

# Nokia Corporation

9 (107)

Installing Flexi Cabinet for Outdoor

Handle

DN70119951

Figure 2.

Lifting handles

Before you start

Check that the cabinet roof is removed.

10 (107)

# Nokia Corporation

DN7062824 Issue 2 en

Lifting the FCOA

Summary

3

Lifting eye bolts (4 places)

Minimum 1500 mm (59.1 in)

2

1

DN7068215

Figure 3.

Lifting the cabinet

WarningFollow the local safety regulations when lifting the cabinet.

Steps1. 2. Attach the 4 x M12 lifting eye bolts to the attachment points. Attach the hoisting belt or rope to the lifting eye bolts.

DN7062824 Issue 2 en

# Nokia Corporation

11 (107)

Installing Flexi Cabinet for Outdoor

Make sure that the hoisting belt or rope loop is high enough to avoid bending the equipment.

CautionA fully equipped cabinet weighs approximately 365 kg. Make sure that the hoisting belt or rope is sufficiently strong.

3. 4. 5. 6.

Lift the cabinet carefully to the desired installation height. Mount the cabinet. Remove the lifting equipment. Install the roof.

12 (107)

# Nokia Corporation

DN7062824 Issue 2 en

Installing the cabinet

44.1

Installing the cabinetAnchoring the FCOAPurpose

The cabinet must be anchored to the base if there is any risk of it toppling in areas with an earthquake risk, for example.Before you start

The site is prepared and ready. When raining, some water may enter the cabinet through the door and back wall. It is important that the water can exit via the holes on the cabinet floor. If the cabinet is exposed to rain, it must be installed at least 20...50 mm off the ground by using, for example, an I-beam rail, metal grating or C-bars.

DN7062824 Issue 2 en

# Nokia Corporation

13 (107)

Installing Flexi Cabinet for Outdoor

Steel structure Cabinet fixing nut Cabinet spring washer20-50 mm off the groundDN70119909DN7062824 Issue 2 en

Anchor bolt

Figure 4.

Anchoring the cabinet off the ground

14 (107)

# Nokia Corporation

Installing the cabinet

Summary

Cabinet fixing nut Cabinet spring washer Anchor bolt Concrete

DN7067649

Figure 5.

Anchoring the cabinet

Steps1. Drill the anchoring bolt holes on the base. See the drilling template in the packing.

DN7062824 Issue 2 en

# Nokia Corporation

15 (107)

Installing Flexi Cabinet for Outdoor

with air filter cables routed via back with air filter and cables routed via side or bottom1000 mm (39.3 in)

75 mm (3.0 in) 620 mm (24.4 in)450 mm (17.7 in)

770mm (30.3 in)

fixing points

Front side770mm (30.3 in)

DN70119963

Figure 6.

Anchoring bolt locations

2. 3. 4. 5.

Attach the anchoring bolts to the base. Position the cabinet on the anchoring bolts. Fix the nuts on the anchoring bolts. Check that the cabinet is level.

16 (107)

# Nokia Corporation

575 mm (22.6 in)

DN7062824 Issue 2 en

Installing the cabinet

6.

Tighten the nuts to 49 Nm.

4.2

Changing the opening direction of the FCOA doorPurpose

The door opening direction can be changed.

Steps1. Detach the wind stopper from the door.

2 1

DN7073576

2. 3.

Detach the wind stopper from the c