Copyright 2006 SPiiPlus Training Class Simple IB23810 Motor Setup.

Copyright 2006

SPiiPlus Training Class

Simple IB23810 Motor Setup

2Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 1: Connect your serial/ethernet cable to the computer and PCI board.

Step 2: Open up the MMI and SPiiPlus UMD if necessary.

Step 3: Set your communication settings to serial or ethernet, select either correct COM port for serial, or correct IP address for ethernet.

Step 4: When connection is established, you will see the firmware version displayed in the MMI window. After this, close the communication window.

3Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 5: Go to Setup -> Configurator . Step 6: Select X Axis Step 7: Open the Motor Flags Button. Make

sure only bits 17, and 19 are set (Note that a 1 input drive is handled as a DC Brush motor). Close the Motor Flags window.

Step 8: Set EFAC = [360(degrees/turn)]/[4000(counts/turn)] = 0.09

Step 9: Set VEL=1080, ACC=10000, DEC=10000, JERK=100000, KDEC=100000

4Copyright 2006

SPiiPlus Training Class

Setting up the Motor

5Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 10: Click the ‘Safety Parameters’ button. Step 11: Set XVEL=18000, XACC=500000,

XRMS=30; XCURI=30; XCURV=50; leave other parameters.

Step 12: From Configurator, click ‘Save to Flash’. Close Configurator window when done saving.

6Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 13: Goto Setup -> Adjuster -> Axis Setup Step 14: Under General Tab:

7Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 15: Under Drive Tab:

8Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 16: Under Motor Tab:

9Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 17: Under Position Feedback Tab:

10Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 18: Under Velocity Feedback Tab:

Step 19: Click ‘Calculate Parameters and Close’, and then click ‘OK’, and save to flash

11Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 20: Open Terminal from MMI and type ‘ENABLE X’. If you get a driver alarm, go back into Configurator -> Safety Parameters, and click checkbox corresponding to ‘Drive Alarm’ and ‘SAFINI’. Then close Safety Parameters.

Step 21: From Configurator, click ‘Copy Axis’ and copy X axis to Y, Z, and T axes. When done, close Configurator.

Note: Current loop tuning is only available for integrated drive controllers.

Note: Commutation is not required for single input external drives (drive provides commutation).

12Copyright 2006

SPiiPlus Training Class

Setting up the Motor

Step 22: Save your application with the Application Saver

Step 23: Done with setup, now ready for Tuning.