SPECIFICATIONS TROUBLESHOOTING INSTALLATION CHECK POINT Water leaks around the handle 1 Tighten Handle is loose 2 Tighten Plug cannot open and close 3 Tighten Flow rate unsatisfactory 4 Remove and clean PROBLEM SOLUTION 1. CONNECTING NUT 2. BOLT 3. BOLT "COCKTAIL" SINGLE LEVER LAVATORY FAUCET W/ 1¼" POP-UP WASTE S06845B 2. 1. Plug Siphon Packing Triangle Packing Nut Pivot Rod Packing Bolt Kick Box Bolt 302 120 max.30 46 38~51 PF1¼ 115 77 45° Max. 230 53 G½ Ø62 OPEN Bottom Setting Bolt Washer Setting Nut Packing Lift rod Faucet Pop-Up Clip 3. Slip Washer OPERATING CONDITIONS Water supply pressure : 0.05 ~ 0.75 MPa Ensure that water supply is clean ( No Sand, Dirt, Etc.). 1. 2. 4. FLOW REGULATOR MAINTENANCE Always wipe chrome plated area with dry soft cloth, and sometimes wipe it with cloth soaked in mild soap. Clean the Flow Regulator periodically with soft brush 1. 2. Flow Regulator ATTENTION Use of abrasive cleaning material such as; detergents containing hydrochloric acids, thinner, polishing powder, and nylon brush is not recommended R3 To Cold Water Supply To Hot Water Supply TX115LKBR Washer