Top Banner
e-mail : [email protected] WAT-121 Audio Tally Control Unit / WAT-121 Onair Lamp / WOL-100, WOL-100D Feartures Technical Specification Audio Tally Control Unit On air Lamp WAT-121 Audio Tally Control Unit Rear View WOL-100 On air Lamp (Red 1 Color) WOL-100D On air Lamp (Red / Green 2 Color) Off Off On Air On Air Stand by Ordering Information WAT-121 10 Channel audio tally control unit WOL-100 ONAIR lamp Lamp Lamp WOL-100D 2 Color ON AIR Lamp Audio Tally Control Unit (WAT-121) Channel status LEDs Dry contact or voltage control inputs Dry contact or voltage control outputs On air & speaker mute control 19 1 Rack unit type On air Lamp (WOL-100 / WOL-100D) Front & side display LED type Input tally AC 110V / 220V(WOL-100) AC 220V(WOL-100D) Audio Tally Control Unit (WAT-121) Tally input 10CH Control(start / stop) output 8CH On air / mute control output 2CH On air output Mute output Power Operating temperature Dimensions On air Lamp (WOL-100) On air display lamp Tally input Power Dimensions On air Lamp (WOL-100D) On air display lamp Tally input Power Dimensions Note : Specifications are subject to change without notice WOL-100 / WOL-100D Rear View 본 장비는 방송국의 조정실에 설치되어 외부 Tally의 제어를 받아 On airlamp의 On/off 및 Speaker/signal mute의 동작을 수행한다. 또한 주변 방송 장비(Tape recorder, CDP등)의 Start /stop 동작 및 표시 등의 On/off를 제어할 수 있는 장비로서, 각각의 Tally입력 및 제어출력간 의 연결이 Matrix형태로 설계되어 있어 별도의 장비를 추가하지 않고서도 사용자가 자유롭게 조합(1:1, 1:N, N:1)하여 사용할 수가 있으므로 편리하다. 장비 전면에서 장비를 사용하는 환경에 알맞게 각 채널별로 기능 설정(전압 /접점, 펄스 /연속)을 할수 있어 사용 환경에 따른 다양성을 제공한다. 본 장비는 방송국의 조정실 및 Studio에 설치하여 방송 제작 및 송출 시 방송 중임을 표시하는 장치이다. WOL-100은 On Air시 적색으로 점등되며 WOL-100D는 Stand by시 녹색으로, On Air시 적색으로 점등된다. 접점식 /전압식 CH별선택 접점 입력 On저항 =1200ohms이하 전압 입력 On=3.5V ‾ 12V 1mA이하 /Off=2V이하 펄스 /연속 CH별선택 접점 /전압 CH별선택 NO /NC CH별선택 5V /12V CH별선택 (전압 출력 시) 전압출력 25mA /CH 고휘도 적색 LEDtype 제어 전류 10mA이내 110/220Volts, AC 60Hz, 2W 270(W) X78(H) X60(D)mm 고휘도 적색 /녹색 LED type 적색 /녹색 각 제어 전류 10mA이내 220Volts, AC 60Hz, 3W Optional AC 110Volt 270(W) X78(H) X60(D)mm 장비 전원 전압 2CH Stereo2CH (mono4CH) AC 85V ‾ 264V, 50/60Hz 0 C‾ 45C 483(W) X44(H) X350(D)mm
1

Audio Tally Control Unit / WAT-121 Onair Lamp /bronics.co.kr/sub/pdf/WAT-121.pdf ·  · 2010-08-16e-mail : [email protected] WAT-121 Audio Tally Control Unit / WAT-121 Onair Lamp

May 02, 2018

Download

Documents

phungkhanh
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Page 1: Audio Tally Control Unit / WAT-121 Onair Lamp /bronics.co.kr/sub/pdf/WAT-121.pdf ·  · 2010-08-16e-mail : si@bronics.co.kr WAT-121 Audio Tally Control Unit / WAT-121 Onair Lamp

e-mail : [email protected]

WAT-121

Audio Tally Control Unit / WAT-121Onair Lamp / WOL-100, WOL-100D

Feartures

Technical Specification

Audio Tally Control Unit

On air Lamp

WAT-121 Audio Tally Control Unit Rear View

WOL-100 On air Lamp (Red 1 Color) WOL-100D On air Lamp (Red / Green 2 Color)

Off 상태

Off 상태

On Air 상태

On Air 상태

Stand by 상태

Ordering Information WAT-121 10 Channel audio tally control unit WOL-100 ONAIR lamp

Lamp Lamp

WOL-100D 2 Color ON AIR Lamp

Audio Tally Control Unit (WAT-121) Channel status LEDs Dry contact or voltage control inputs Dry contact or voltage control outputs On air & speaker mute control 19 1 Rack unit type

On air Lamp (WOL-100 / WOL-100D) Front & side display LED type Input tally AC 110V / 220V(WOL-100) AC 220V(WOL-100D)

Audio Tally Control Unit (WAT-121)Tally input 10CH

Control(start / stop) output 8CH

On air / mute control output 2CHOn air outputMute output

Power

Operating temperature

Dimensions

On air Lamp (WOL-100)On air display lampTally inputPowerDimensions

On air Lamp (WOL-100D)On air display lampTally inputPower

Dimensions

Note : Specifications are subject to change without notice

WOL-100 / WOL-100D Rear View

본 장비는 방송국의 조정실에 설치되어 외부 Tally의 제어를 받아 On air lamp의 On/off 및 Speaker / signal mute의 동작을 수행한다. 또한 주변 방송 장비(Tape recorder, CDP등)의 Start / stop 동작 및 표시 등의 On/off를 제어할 수 있는 장비로서, 각각의 Tally 입력 및 제어출력간의 연결이 Matrix 형태로 설계되어 있어 별도의 장비를 추가하지 않고서도 사용자가 자유롭게 조합(1:1, 1:N, N:1)하여 사용할 수가 있으므로 편리하다.장비 전면에서 장비를 사용하는 환경에 알맞게 각 채널별로 기능 설정(전압 / 접점, 펄스 / 연속)을 할수 있어 사용 환경에 따른 다양성을 제공한다.

본 장비는 방송국의 조정실 및 Studio에 설치하여 방송 제작 및 송출 시 방송 중임을 표시하는 장치이다.WOL-100은 On Air시 적색으로 점등되며 WOL-100D는 Stand by시 녹색으로, On Air시 적색으로 점등된다.

접점식 / 전압식 CH별선택접점 입력 On 저항 = 1200 ohms 이하전압 입력 On = 3.5V ‾ 12V 1mA이하 / Off=2V이하

펄스 / 연속 CH별선택접점 / 전압 CH별선택NO / NC CH별선택5V / 12V CH별선택 (전압 출력 시)전압출력 25mA / CH

고휘도 적색 LED type제어 전류 10mA이내110 / 220 Volts, AC 60Hz, 2W270(W) X 78(H) X 60(D)mm

고휘도 적색 / 녹색 LED type적색 / 녹색 각 제어 전류 10mA이내220 Volts, AC 60Hz, 3WOptional AC 110Volt270(W) X 78(H) X 60(D)mm

장비 전원 전압 2CHStereo 2CH (mono 4CH)

AC 85V ‾ 264V, 50 / 60Hz

0 C‾ 45 C

483(W) X 44(H) X 350(D)mm